abstract

• This paper presents the converter design of a single-phase non-isolated step-down controlled rectifier for power factor improvement and output voltage regulation. The converter consists of a full-bridge diode rectifier and a DC–DC interleaved buck converter of two or more switching cells that has an LC filter in its input. It is proposed that the interleaved switching cells operate in discontinuous conduction mode and the current through the input LC filter be continuous, avoiding switching frequency components to be injected into the grid. The controller, which has a simple structure and a small number of sensors, allows the system to achieve a high power factor. It also regulates the output voltage to a constant reference. An experimental prototype is built and tested to validate the analysis and proposed design. The closed-loop converter is evaluated both in a steady state and in transient conditions. At steady state, the converter achieves a power factor above 0.9 with a maximum of 45.4%25 THD at 110.1W. The main contributions of this paper are guidelines for the design of the converter, open-loop analysis, and converter control.

authors

• Martínez Rodríguez Pánfilo Raymundo
• Vazquez-Guzman G.

publication date

• 2023-01-01

published in

• Micromachines   Journal

keywords

• PFC, rectifier, interleaved buck converter, AC–DC, LC filter

Digital Object Identifier (DOI)

• 10.3390/mi14030511

PubMed ID

start page

• 1

end page

• 16

volume

• 14

issue

• 3